3.1.1 Self-Teach Procedure; Operations Available In; Limit Switch Adjustment (Optional); Programming - Aprimatic R1-24 Instrucciones Para La Instalación, Uso Y Mantenimiento

presence of limit switches connected (opening and closing);
presence of electric lock connected; note: the reverse
stroke is enabled automatically when the electric lock and
closing mechanical stop are fi tted.
NOTE: the self-teach process is disabled if the automation
is only powered by the batteries.
!
Warning External signals are ignored during the
self-teach procedure except for the photocell during closing
and STOP signals. If these signals are triggered the self-
teach procedure is stopped and must be repeated.
FORCED SELF-TEACHING
After a RESET, or when any of the "speed" (
A9 Ab
ramp incline ( or
parameters are re-programmed or the number of motors
connected (even temporarily) is changed, the SELF-TEACH
Lrn
PROCEDURE (" " fl ashing on the display unit) must be
repeated.

3.1.1 SELF-TEACH PROCEDURE

Press the YELLOW and BLUE buttons simultaneously
Lrn
" " fl ashes on the display panel (Fig.4).
Press the START button
closing cycles are performed as described in Fig.4. The
self-teach procedure then ends with the gate closed and
the display panels are switched OFF.
Operation is now possible using the key button or a
programmed remote control unit to check correct functioning.
NOTE: after the self-teach procedure the default
functioning configuration is automatic with the
factory settings (see tab. Programmable parameters).
3.1.2 OPERATIONS AVAILABLE DURING "
The following operations can be performed when "
is fl ashing on the display unit (when the yellow and blue
buttons are pressed or in forced self-teach status):
SPECIAL OPERATION during "
This type of operation is useful before the self-teach
procedure begins to close the gates and/or to adjust the
position of the limit switches.
To move wing 1, press and hold down the YELLOW button
on the unit;
To move wing 2, press and hold down the BLUE button.
Each time the YELLOW or BLUE button is released and
then pressed again, the movement of the relevant wing is
reversed.
ADJUSTING THE LIMIT SWITCHES (OPTIONAL)
Adjust the position of the limit switch on the operator and
move the gate (red or yellow button)
is reached the gate stops and the code for the limit switch
programmed is shown on the display unit:
A2
opening, = wing 2 opening,
= wing 2 closing. When the positions required are obtained,
start the self-teach procedure (START button).
PROGRAMMING OF PARAMETERS
Press the RED button to access programming (see relevant
section).
SPE
) or approach distance (
consecutive opening and
Lrn
":
Lrn
" status:
when the limit switch
A1
= wing 1
C1
= wing 1 closing,
gate closed or
partly open
),
on the display:
Ac
)
F A 1
1
1
on the display:
F A 1
2
complete closing (slow speed)
Lrn
"
on the display:
F A 2
1
on the display:
F A 2
C2
- 25 -
System start-up / Self-teach
Self-teach
Yellow Blue
3 "
START
complete opening (slow speed)
2
3
complete opening
4
complete closing
2
gate closed
Fig. 4
on the
display:
l r n
display: