Startup Operation; Charging The Battery; Using The Device - Clatronic MPS 2681 Instrucciones De Servicio

1. Charge the rechargeable battery of the motor unit (see chapter "Charging the battery").
2. Attach the required attachment. Remove / attach the attachments by simply sliding them
off or onto the shaft of the motor unit.
1. Turn off the device by sliding the on /off switch of the motor unit down.
2. Connect the mains adapter to the socket.
3. Connect the mains adapter to a certified wall socket. Charge the device for 14 hours
before first-time use.
NOTE:
• The indicator lamp lights up red during charging operation.
• The lamp does not indicate the charging status of the device.
• It is normal for the device to heat up during charging.
4. Stop any charging operation after a maximum of 14 hours.
ACHTUNG:
Always disconnect the plug from the wall socket after 14 hours of charging.
NOTE on battery life:
Observe the following in order to prolong battery life:
• Charge the battery only when it is almost empty.
• Charge the device at an ambient temperature between 0° and + 40°C.
HINWEIS:
Wash your hands and feet or apply lotion to them only after treatment.
1. Turn on the device. To do so, slide the on / off switch up.
2. Gently run the attachment past the treatment area.
3. In order to prevent injuries, check the progress of the treatment continuously at short
intervals.

Startup operation

Charging the battery

Using the device

GB
43