Engine Preparation - Powermate PWFTA17322 Manual Del Operador

Engine Preparation

• Save all instructions
A
Engine Oil
NOTICE
Engine shipped without oil. Failure to add oil will result in
serious engine damage.
A bottle of engine oil is included with your Trimmer. Refer to
Figure 9 for alternative oil types to use at different tempera-
tures. Always use a high quality detergent oil classified "For
Service, SG, SH, SJ" or higher. Do not use special additives.
Always use recommended oil type. Using dirty oil or incorrect
oil type such as 2-stroke engine oil will shorten engine life.
HOW TO CHECK OIL LEVEL AND FILL TO PROPER LEVEL
WARNING
Before checking oil, make sure engine is off, and spark
plug wire has been disconnected from spark plug.
1. Place trimmer on a level surface.
2. Remove Dipstick and wipe clean with cloth. Refer to
Figure 10 for location of Dipstick.
3. Replace Dipstick and do NOT screw it. Remove and
check oil level.
4. When oil level is full, the oil will be at upper limit on dip
stick. If oil level is near or below the lower limit, oil must
be added. (See Figure 10)
5. Add oil slowly until the oil level reaches the upper limit of
the dipstick. Use a funnel or nozzle to reduce spillage.
NOTICE
Frequently check oil level while filling.
DO NOT OVERFILL. DO NOT UNDERFILL. Running
engine at improper oil level will seriously damage engine.
6. Replace and tighten dipstick.
7. Clean up any spilled oil.
Questions? Call Toll Free at 1-800-737-2112
SAE
TEMP
-20
0
-30 -20 -10
Ambient Service Temperature
Upper Limit
Lower Limit
EN - 9
Copyright © 2018 MAT Engine Technologies, LLC
SAE 10W-30
SAE 30
20 60 80
40
0 10 20
Figure 9
100° F
30 40° C
Figure 10