Working Mode; Power Saving Mode - Smanos X330 Manual Del Usuario

EN

Working Mode

Testing Mode
Press the test button, the detector enters testing mode and detects once every
10 seconds. After 3 minutes, the status indicator blinks twice, and the detector switches
to power saving mode.

Power Saving Mode

If the PIR motion detector detects movements twice in 3 minutes, it automatically goes
into a sleep state. If there is no movement detected in next 3 minutes, it will switch from
sleep state to arm. During the 3 minutes, the detector won't be active and send any
signals to the control panel. As long as there is a movement detected within 3 minutes,
the duration of power saving mode will be extended.
Case 1: Case 2:
Initial start and then arm. Press the test button and then arm.
3 minutes later
Sleep after detecting human movement twice.
No human movement within 3 minutes
Switch from sleep to arm.
29
X330-UM-EN-FR-ES-PT-V1.0.indd 29-30
Installation
Important: Avoid installing the motion detector directly toward windows or near heat
sources, such as heat extraction units, air-condition, micro-wave oven, refrigerator etc.
Also try to avoid placing two motion detectors in the opposite of each other and don't
place them in each other's detection range.
EN
30
2016/8/19 15:41:14