Service Mode - Smanos SS2603 Manual Del Usuario

EN
When installed as Siren
only Alarm System (without
control panel). All of the
Alarm Accessories must be
paired to the Siren.
The Siren will sound and the
strobe light will flash upon
activation of a connected
Accessory.
Disarming the System will
stop the siren sounding. If
not disarmed the Siren Status
Indicator will flash once every
2 seconds for one hour (visual
notification of an alarm event).
Note: Press and hold the pair button of the wireless siren; the connection
between the wireless siren and control panels (or accessories) is deleted
when you hear a beep from the wireless siren.
Pairing with Wireless Accessories
1. Press the Learn Button
(0.5 seconds), the system goes
into Learn Mode after one beep
is heard.
2. Press the Test Button on the
additional Accessory or trigger
the Accessory once.
3. The Wireless Accessory is
learned successfully after a
second beep.
4. If two beeps are heard, the
accessory is already linked.
To give up pairing the Accessories,
press the Learn Button (before step
2 is done) again to exit Learn Mode
after one beep.
Installation

Service Mode

Test Mode prevents the Siren's tamper switch from triggering
an alarm during installation, maintenance or when changing
the battery.
When the remote control is connected with the siren, press
[Disarm ] 3 times successively (please make sure two beeps
are heard at each time before continuing the next press), the
siren goes into service mode when a long beep is heard.
During this period, the siren will not alarm but beep if the
tamper switch or the connected sensors are triggered. This
brings you convenience on installation.
Press [Arm ] on remote control to exit service mode after a
short beep.
Note: Also you can press the tamper switch 7 times to enter installation
mode.
Hold the mounting plate
Remove the fixing
in position and mark
screw from the
the positions of the four
bottom edge of the
mounting holes. A spirit
siren housing and
level placed on the water-
carefully remove front
proof casing will ensure a
cover.
perfect level.
Hinge the front cover
Drill four holes and
locating tabs over the top
fit the wall plugs,
edge of the back plate and
and then fit supplied
carefully push the base of
fixing screws in the
the siren cover into place.
holes.
Secure the siren cover
in place by refitting the
fixing screw in the bottom
edge of the cover.
EN