Safety Information; Safety Precautions - OHAUS VE Serie Guia Del Usuario

Ocultar thumbs Ver también para VE Serie:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 5
VE Series Floor Scale

1. SAFETY INFORMATION

Definition of Signal Warnings and Symbols
WARNING
CAUTION
Attention
Note
Warning Symbols
General hazard

Safety Precautions

CAUTION: Read all safety warnings before installing, making connections, or servicing this equipment.
Failure to comply with these warnings could result in personal injury and/or property damage. Retain all
instructions for future reference.
Verify that the local AC power supply voltage is within the input voltage range printed on the AC adapter's ratings label.
Only connect the AC adapter to a compatible grounded socket.
Position the instrument such that the AC adapter can be easily disconnected from the socket.
Position the power cord so that it does not pose a potential obstacle or tripping hazard.
Operate the equipment only under ambient conditions specified in the user instructions.
Do not operate the equipment in hazardous or explosive environments.
Disconnect the equipment from mains power before cleaning or servicing.
Service should only be performed by authorized personnel.
Intended Use
Use the instrument exclusively for <weighing/moisture determination/etc.> as described in the operating instructions. Any
other type of use and operation beyond the limits of technical specifications without written consent from OHAUS, is
considered as not intended.
This instrument complies with current industry standards and the recognized safety regulations; however, it can constitute a
hazard in use.
If the instrument is not used according to these operating instructions, the intended protection of the instrument may be
compromised and OHAUS assumes no liability.
2. INSTALLATION
CAUTION: THE FLOOR SCALE IS VERY HEAVY, ALWAYS USE AN APPROPRIATE HOIST TO LIFT IT
FROM THE PACKAGING OR TO MOVE IT INTO THE REQUIRED POSITION.
2.1 Positioning
Ensure the surface is flat in the area where the scale will be positioned, especially in the region of the load cell feet. Small
differences in height can be compensated by adjusting the load cell feet.
1.
If an Indicator is included with the floor scale ensure that it is kept with the floor scale during positioning
as there may be an attached connecting cable.
2.
With the floor scale positioned over the final work area, remove the 4 shipping feet (if installed).
3.
Install the 4 load cell feet (if not already installed).
4.
Lower the scale on to the final work area.
5.
Check that the floor scale is level; check that the 4 feet are in contact with the floor; make adjustments by
rotating the nuts on the load cell feet. Use an external level.
6.
Ensure that the floor scale's output cable does not become trapped or crushed during lifting or positioning.
For a hazardous situation with medium risk, possibly resulting in injuries or death if not avoided.
For a hazardous situation with low risk, resulting in damage to the device or the property or in loss
of data, or injuries if not avoided.
For important information about the product.
For useful information about the product.
Electrical shock
EN-1
Tabla de contenido
loading

Tabla de contenido