Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
Detachable Front Panel
Caution
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during
installation, you might press too hard and warp the
metal plate that holds it in place.
• The main unit must be mounted within 35 degrees of the
horizontal plane, back to front.
Less than 35°
1
Mounting Sleeve
(Included)
Pressure
*
Plates
This unit
* If the installed mounting sleeve is loose in the
dashboard, the pressure plates may be bent slightly to
remedy the problem.
Remove the mounting sleeve from the main
unit (see "Removal" on page 27).
2
Hex Nut (M5)
Metal Mounting
Strap
Ground Lead
Chassis
Dashboard
Screw
2
*
Bolt Stud
1
*
This unit
Reinforce the head unit with the metal
mounting strap (not supplied). Secure the
ground lead of the unit to a clean metal spot
1
using a screw (*
) already attached to the
vehicle's chassis.
2
• For the screw marked "*
for the chosen mounting location.
Connect each input lead coming from an
amplifier to the corresponding output lead
coming from the left rear of the CDE-121.
Connect all other leads of the CDE-121
according to details described in the
CONNECTlONS section.
3
Slide the CDE-121 into the dashboard until it
clicks. This ensures that the unit is properly
locked and will not accidentally come out
from the dashboard. Install the detachable
front panel.
Removal
1. Remove the detachable front panel.
2. Insert the bracket keys into the unit, along
the guides on either side. The unit can now
be removed from the mounting sleeve.
This unit
3. Pull the unit out, keeping it unlocked as you
do so.
<JAPANESE CAR>
Front Frame
This unit
Ground Lead
3
*
Mounting Bracket
Secure the ground lead of the unit to a clean metal spot
3
using a screw (*
) already attached to the vehicle's chassis.
", use an appropriate screw
Bracket Keys
(Included)
Screws (M5 × 8)
(Included)
27
-EN
Tabla de contenido
