Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CD
CD Player not functioning.
• Out of operating temperature range +50°C (+120°F) for
CD.
- Allow the vehicle's interior (or trunk) temperature to
cool.
CD playback sound is wavering.
• Moisture condensation in the CD Module.
- Allow enough time for the condensation to evaporate
(about 1 hour).
CD insertion not possible.
• A CD is already in the CD player.
- Eject the CD and remove it.
• The CD is being improperly inserted.
- Make sure the CD is being inserted following
instructions in the CD Player Operation section.
Unable to fast forward or backward the CD.
• The CD has been damaged.
- Eject the CD and discard it; using a damaged CD in
your unit can cause damage to the mechanism.
CD playback sound skips due to vibration.
• Improper mounting of the unit.
- Securely re-mount the unit.
• The disc is very dirty.
- Clean the disc.
• The disc has scratches.
- Change the disc.
• The pick-up lens is dirty.
- Do not use a commercially available lens cleaner disc.
Consult your nearest Alpine dealer.
CD playback sound skips without vibration.
• The disc is dirty or scratched.
- Clean the disc; damaged disc should be replaced.
Error displays.
• Mechanical error.
- Press
. After the error indication disappears, insert
the disc again. If the above-mentioned solution does
not solve the problem, consult your nearest Alpine
dealer.
CD-R/CD-RW playback not possible.
• Close session (finalization) has not been performed.
- Perform finalization and attempt playback again.
MP3/WMA/AAC
MP3, WMA or AAC is not played back.
• Writing error occurred. The MP3/WMA/AAC format is
not compatible.
- Make sure the MP3/WMA/AAC has been written in a
supported format. Refer to "About MP3/WMA/AAC"
(pages 12-13), then rewrite in the format supported by
this device.
iPod
iPod does not play and no sound is output.
• The iPod has not been recognized.
- Turn the ignition key off, and then set to ON again.
- To reset the iPod, refer to the Owner's Manual of the
iPod. If the above-mentioned solution does not solve
the problem, consult your nearest Alpine dealer.
Indication for CD Player
• No CD is inserted.
- Insert a CD.
• Although a disc is inserted, "NO DISC" is displayed and
the unit does not start to play or eject the disc.
- Remove the disc by following these steps:
Press the
button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine
dealer.
• Mechanism error.
1) Press the
button and eject the CD.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting,
press the
button again.
If the error indication still does not turn off after
pressing the
button for a few times, consult your
Alpine dealer.
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
• A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate that is supported by the
unit.
23
-EN
Tabla de contenido
