Antivibration Handle; Important - Sima COBRA MKNO Manual De Instrucciones Original

4.4 ANTI VIBRATION HANDLE.
An antivibration handle is available which reduces vibrations and increases comfort for the user. The handle
minimizes fatigue and reduces injuries that can be caused by vibrations.
The handle bar is mounted on a silent block of soft rubber which
absorbs a lot of vibrations.
Changing the handle bar
1. Remove the screws that fix the handle bar in place.
2. Replace the handle bar.
3. Reinsert and fix the screws.
4.5 RAISING/ LOWERING TO CUT.
The machine raises and lowers using a gas shock absorber. This is activated by the lever located on the handle
bar.
RAISING THE MACHINE UP
1. Press the lever down all the way with your
thumb.
2. Press the handle bar down at the same time to
raise the cutting head.
3. When the desired height is reached release the
shock absorber lever and stop pushing down
on the handle bar..
LOWERING TO CUT.
1. Press the lever gently with your thumb to
gauge the downward
machine. Once the lever is fully depressed you
should assume the weight of the machine and
guide it down smoothly so that the machine is
not ´dropped ´and damaged.
2. To stop the raising and/or lowering process release the shock absorber lever.
ADVISE: Practice this a few times before you try to use the machine with a blade.
IMPORTANT: When a blade is mounted the lowering of the machine should be very smooth
until the blade contacts with the surface, once the blade is cutting the machine can be
lowered as normal.
movement of the
8
ENGLISH