Socket; Blowing/Inflating - Kärcher FI6565S Manual Del Usuario

18. When the tank is full a float inside will stop the suction.
! WARNING-Do not operate without filter basket and float, as they prevent liquid from
entering the impeller and damaging the motor. Do not suck up any liquids without a sponge
filter installed.
! WARNING: To reduce the risk of back injury or falls, do not lift a vacuum cleaner heavy with
liquid or debris. Scoop or drain enough contents out to make the vacuum cleaner light
enough to lift in a comfortable manner.
19. To empty the tank, remove the vacuum head, empty tank and reattach the head to tank,
ensuring they are securely clamped together. See instructions in #15.
NOTE: IF ACCIDENTALLY TIPPED OVER, THE VACUUM COULD LOSE SUCTION. IF THIS OCCURS,
PLACE VAC IN UPRIGHT POSITION AND TURN SWITCH OFF. THIS WILL ALLOW THE FLOAT TO
RETURN TO ITS NORMAL POSITION, AND YOU WILL BE ABLE TO CONTINUE OPERATION.
11 – SOCKET FOR POWER TOOLS
The
20. wet-dry vacuum cleaner can be used as a dust extraction system when working together with
power tools.
Before c
21. onnecting the power tool make sure that the load of the power tool does not exceed the
max load stated on the name plate.
Con
22. nect the power tool cord to the socket of the cleaner (A). Connect the power tool adaptor,
Figure1, #17, to the dust exhaust of the power tool and to the suction hose. Turn on the vacuum
cleaner to position II (B). Turn on the power tool and the cleaner will automatically start together
with the power tool.
23. The vacuum cleaner will stop with a delay in order to empty the hose from dust.
12 - BLOWING / INFLATING
24.
To convert from vacuuming to blowing, turn switch off (0). Remove the hose from the
suction inlet, Figure 1, (5), and insert it into the blower outlet, Figure 1 (4). Turn switch on (l).
An optional blower/inflator kit, Figure 9, may be included. This will increase the
10