Balance" Mode - John Bean B 2000P Manual Do Operador

6-15
6-16
6-17
6-18
6-19
84
"BALANCE"
6.3 "PROFILING" Mode
The following instructions describe the specific
functions of the wheel balancer in PROFILING
mode.
The icon shown in fig. 6-15 indicates the BALANCE
mode is active. The unit operates in Automatic
Mode.
When the "BALANCE" mode is set with the set up
panel, the machine performs the automatic wheel
data reading procedure and the user does not have
to perform any setting before the measuring run.
This section sets out the specific functions of the
"BALANCE" mode and only the Menu items that
refer to this mode.
For information about the other items and icons,
refer to the basic chapter "4. Control Elements".
The balancer displays the start screen at power-on.
The screen in fig. 6-16 appears automatically on the
monitor after clamping the wheel.
During the wheel measuring run the screen in fig.
6-17 appears and at the end the weights shown can
be:
- suggested (yellow)
or
- possible alternatives (grey) in the 6 o-clock zone,
precisely where the laser beam indicates they
should be applied (1, Fig. 6-19).
If the Spokes Count is active, the icon in fig. (Fig.
6-18) is displayed during the measuring run.
The possible application of the weights in ways other
than that suggested by the machine is indicated by
the grey weights in the positions compatible with the
rim configuration detected.
Note:
The change in the position of the weight is saved
by the machine, then automatically suggested for
1
all subsequent wheels with the same dimensions.
The selection is deleted when the machine is
switched off.
.. ..........
_