Fan Blade - Electrolux ES560 Manual De Instrucciones

EXPLODED VIEW OF CONVECTION SYSTEM
CONVECTION FAN
MOTOR ASSEMBLY

FAN BLADE

The fan blade is mounted in the rear of the unit and has a "D" shaped mounting hole. Only minimum clearance exists
between the oven back, fan blade, and fan shroud. Be careful not to bend blade when removing or installing.
Access to the fan blade is gained by removing the fan shroud, held in place by three screws, from the inside of the
oven.
The fan blade is held in place with a hex nut that has left handed threads. When removing this nut, gently hold the
fan blade, and turn the nut clockwise. If one of the blades becomes deformed, it may be bent back into shape using
a flat surface as a reference.
A flat washer is located on the motor shaft between the snap ring on the shaft and the fan blade.
NOTE: If the fan blade is bent and motor vibrations increase, the noise made by the fan will be greater.
MOUNTING PLATE OVEN
The fan motor on the rear of the unit is mounted to the main back (with three screws). There is a mounting plate
held in place between the main back (with 2 screws) and the rear oven wall (with 2 screws). Should it be necessary
to replace the oven cavity, you must remove the 2 screws located inside the unit at the rear of the oven cavity.
COOLING FAN MOTOR
The 120 volt fan motor is located on the outside of the rear of the oven. The cooling fan has 2 speed options, which
are driven by the oven controller. The high speed mode is used on self-clean when the temperature gets over 575F.
The high speed is also used anytime the broil function is used. The cooling fan may remain at high speed after the
broil function is cancelled to allow better cooling of the oven. On double wall ovens, the blower in both ovens will
start when using one of the ovens in self-clean mode.
MOUNTING PLATE
OVEN CAVITY
CONVECTION
FAN BLADE
CONVECTION
FAN COVER
8
FLAT WASHER
FAN NUT
CONVECTION
ELEMENT
FAN COVER
SCREWS