Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ENGLISH
Before commencing with the installation of this appliance make sure that you have read
the following instructions carefully. In particular familiarise yourself with the safety de-
vices required by the system, only then will you be able to use them to great effect.
Not all of the safety devices required by the local safety standards have been taken into
consideration in this manual. The installer must make sure that any eventual safety de-
vices required by the local standards and regulations have been installed both ahead of
and after the products described in this manual.
This appliance must be used exclusively for the purpose for which it has been made.
Any non authorised modifications are to be considered improper and therefore danger-
ous. The manufacturer accepts no liability for damage caused by, or situations arising
from, the improper use of these appliances and therefore all work carried out after the
delivery of the appliance is to be considered the complete responsibility of the installer.
These instructions are aimed at professionally qualified "installers of electrical equip-
ment" in conformity with the local standards and regulations in force.
Description
- the electronic components consist of a mother board with an extractable logic card inserted into one of
the interface slots.
- all weather container in ABS with a stainless steel hinged inspection door (180° opening angle), door
sealing gasket (IP 55)
- lockable inspection door with security mains switch
- container fitted with wall fastening elements
- power cable inlet complete with cable clamp
- low power terminal board connections
- radio control receiver interface
- external control buttons (available on request)
INSTALLATION INSTRUCTIONS
Technical specifications
Threephase power supply
Singlephase power supply
Frequency
Motors
Maximum power consumption motors (threephase)
Maximum power consumption motors (singlephase)
Short circuit current with fuses
Nominal current input
Operating temperature
Protection grade
Protection grade with external control buttons
Fire protection grade
Container fitted with cable clamps for Ø16 mm pipes
The PRG383 kit contains:
- The programmer PRG383
- A series of wall mounting screws and rawlplugs etc.
- Nr. 2 keys
- The instruction manual
Positioning
Depending on the type of installation work out the position in which the programmer will be situated
remembering that the site must be:
- a position safe from accidental collision
- high enough above the ground to be safe from pools of water
- in a position which the technician can easily reach.
REMARKS
8
ENGLISH
Vac
400V3~
Vac
Hz
Nr.
W
W
Amp.t<300 ms
Amp
°C
-20...+55
IP
IP
UL94
230V~
50-60
1
700
370
20
3
55
54
V0
Tabla de contenido
