Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
TO iNSTALL SHIFTER LEVER KNOB
®
Thread the shifter lever knob onto the threaded end
of the shifterlever until it is snug againstthe hex nut
and the tip is pointed toward the engine.. Tighten the
hex nut against the bottom of the shift lever knob (See
Fig. 6).
FIG. 6
TO CHECK/ADJUST
CLUTCH
CONTROL CABLES
The control cables, Fig 7, attached to the auger clutch
lever and traction clutch lever may need to be adjusted
before you use your snow thrower_
For instructions on checking or adjusting the control
cables, see ToAdjust Clutch Control Cables paragraphon
page 19.
i
llu
ii
i ,llllll,i llllIHN, lll
TRACTIONCLUTCH LEVER
AUGER CLUTCH LEVER
OFF
CONTROLCABLES
FIG.7
,/
CHECKLIST
BEFORE
YOU OPERATE
AND ENJOY
YOUR NEW
SNOW THROWER,
WE WISH TO ASSURE
THAT YOU
RECEIVE
THE
BEST
PERFORMANCE
AND
SATISFACTION FROM THIS QUALITY PRODUCT
PLEASE REVIEW THE FOLLOWING CHECKLIST:
/
All assembly instructionshave been completed
J
The discharge chute rotates freely
4'
No remaining loose parts in carton,
WHILE
LEARNING
HOW
TO
USE
YOUR
SNOW
THROWER,
PAY
EXTRA
ATTENTION
TO
THE
FOLLOWING IMPORTANT tTEMS:
,f=f Engine oil is at proper lever
/J
Make sure gas tank is iiiled properIy with clean, lresh,
unleaded gasoline
_J
Become familiar
with all controls-their
location and
function, Operate controls before starting engine
9
Tabla de contenido
