Tabla de contenido
Idiomas disponibles
Idiomas disponibles
......................
mmmlm
I
""
..........
SERVICE AND ADJuS rMEN rs
CAUTION: ALWAYS DISCONNECT THE
SPARK
PLUG WIRE AND TIE BACK
AWAY FROM THE PLUG BEFORE MAK-
ING ANY ADJUSTMENTS OR REPAIRS.
mHimmmmml
mmmm,
,_,,,,,,,_,_,,
TO ADJUST SKID HEIGHT
This snow thrower is equipped with two height adjust -_
ment skids, located on the outside of the auger housing
(See Fig, 21), These skids elevate the front of the snow
thrower,
For normal hard surfaces, such as a paved driveway or
walk, adjust the skids as follows:
Check tire pressure (14 to t7 pounds)
Place the extra shear bolts supplied (found in pads
bag) under each end of the scraper bar near but not
under the skid.
O
®
®
Loosen the skid mounting nuts (See Fig. 21), and
adjust the skids to allow the front of the snow thrower
to rest on the shear bolts, Retighten the mounting
nuts°
®
Set the skid on the other side at the same height°
NOTE: For graveled or uneven surfaces, raise the front
of the snow thrower by moving the skids down This will
helpprevent rocks and other debris from being picked up
and thrown by the auger.
TO ADJUST SCRAPER BAR
After considerable use, the metal scraper bar will have a
definite wear pattern. The scraper bar in conjunction with
the skids should be adjusted to allow 1/8" between the
scraper bar and the sidewalk or area to be cleaned_ The
scraper bar may have to be returned to itsoriginal lower
setting to maintain the original performance level. To
adjust:
®
Positionthe snow thrower on a level surface,
®
Make sure both tires are equally inflated. Proper tire
pressure is 14to 17 PSL See side of tirefor maximum
inflation. Do not exceed sidewall maximum pressure
on tire,
®
®
Q
®
Loosenthecarriage bolts and nuts secudngthe scraper
bar to the auger housing_
Adjust the scraper' bar to the proper' position
Tighten ttle carriage bolts and nuts, making sure that
the scraper bar is parallel with the working surface
For extended operation, the scraper bar may be
reversed, if the scraper bar must be replaced due to
wear, remove the carriage bolts and nuts and install a
new scraper bar:
SKID MOUNTING NUTS
AUGER HOUSING
HEIGHT ADJUST SKID
FIG. 21
...............
CAUTi0N;'
BE CERTAIN TO MAINTAIN
PROPER GROUND CLEARANCE
FOR
YOUR P ARTICULAR
AREA To BE
CLEARED. OBJECTS SUCH AS GRAVEL,
STONESOROTHERDEBRIS,IFSTRUCK
BY THE IMPELLER, MAY BE THROWN
WITH SUFFICIENT FORCE TO CAUSE
PERSONAL INJURY, PROPERTY DAM-
AGE OR DAMAGE
TO THE SNOW
THROWER.
18
Tabla de contenido
