Using The Machine - EMAK TN 4500 Manual De Uso Y Mantenimiento

water. The warranty does not cover for
damage to plastic parts of the bodywork or
I
the engine caused by petrol.
- Loosen fuel cap slowly to release pressure
and to keep fuel from escaping around the
GB
cap.
- Clean surface around fuel cap to prevent
contamination.
- Prior to replacing the fuel cap, clean and
F
inspect the gasket.
- Tighten fuel cap securely after refuelling. Unit
vibration can cause an improperly tightened
D
fuel cap to loosen or come off and spill
quantities of fuel.
- Wipe spilled fuel from the unit and allow
E
remaining fuel to evaporate. Move 3 m away
from refuelling site before starting engine.
- Never attempt to burn off spilled fuel under
NL
any circumstances.
- Never place the machine in an area with
combustible materials such as dry leaves,
straw, paper, etc.
P
- Never take the cap off the tank when the
engine is running.
- Take care not to get fuel on your clothing. If
H
you have spilled fuel on yourself or your
clothes, change your clothes. Wash any part
of your body that has come in contact with
SK
fuel. Use soap and water.
- Do not expose the fuel tank to direct sunlight.
- Store and transport fuel in a clean container
CZ
approved for petrol.
- Store fuel in a cool, dry, well-ventilated place.
- Store the unit and fuel in an area where fuel
RUS
vapours cannot reach sparks or open flames
UK
from water heaters, electric motors or
switches, furnaces, etc.
- Keep fuel out of reach of children.
PL
- Never use fuel for cleaning operations.
WARNING
FIN
- Refuelling should be carried out in an
open and well-ventilated area with the
BIH
engine off. Always remember that petrol
SRB
fumes are inflammable. DO NOT USE A
HR
NAKED FLAME TO LOOK INSIDE THE TANK
AND DO NOT SMOKE WHEN REFUELLING.
- Check for fuel leaks, if any are found,
correct before use. Contact an authorised
service workshop if necessary.
30
CAUTION - Never use a fuel with an
ethanol percentage higher than 10%;
gasohol (mixture of gasoline and
ethanol) up to 10% ethanol or E10 fuel
are acceptable.
Alkylate gasoline
CAUTIONS – Alkylate fuels have different
density than normal fuel. Therefore
engines, set with normal fuel, need
different H jet regulation to avoid critical
issues. For this operation it's necessary
turned at a Licensed Service Dealer.
After having removed the fuel cap (4, Fig.2)
refuel using a funnel, but do not completely fill
the tank.
Checking machine safety and efficiency
WARNING: Do not use the machine if
you are unsure whether it is working
safely or efficiently. If in doubt, contact
your Dealer immediately to make the
necessary checks and repairs.

6.2 Using the Machine

Starting
CAREFULLY READ THE ENGINE INSTRUCTION
MANUAL.
WARNING: The engine must be started
in an open or well-ventilated area.
ALWAYS REMEMBER THAT EXHAUST
GASES ARE TOXIC.
WARNING
- Before starting the engine, check the
correct operation of the controls.
- Do not touch the muffler or the engine
while it is running or immediately after
stopping it. These parts can become very
hot.
- Do not leave the machine unattended with
the engine running. Stop the engine