Zanussi ZDV 14001FA Manual De Instrucciones página 22

1. Adjust the water softener to the lowest lev-
el.
2. Set the rinse aid dispenser to the lowest
position.
If you stop to use the combi detergent
tablets, before you start to use separately
detergent, rinse aid and dishwasher salt,
do these steps:
1. Press the on/off button to activate the appli-
ance.
2. Set the water softener to the highest level.
3. Make sure that the salt container and the
rinse aid dispenser are full.
4. Start the shortest programme with a rinsing
phase, without detergent and without
dishes.
5. Adjust the water softener to the water hard-
ness in your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to ac-
cept some operations.
The appliance is in setting mode when, after
the activation, all the programme indicators
come on.
If the control panel shows other conditions,
press and hold function buttons (B) and (C) at
the same time until the appliance is in setting
mode.
Starting a programme without delay start
1. Open the water tap.
2. Press the on/off button to activate the appli-
ance. Make sure that the appliance is in set-
ting mode.
3. Press the button of the programme you
want to set.
• The related programme indicator stays
on.
• All the other programme indicators go off.
4. Close the appliance door. The programme
starts.
22
Starting a programme with delay start
1. Set the programme.
2. Press the delay button again and again until
the indicator of the number of hours you
want to set comes on. You can set 3, 6 or 9
hours.
• The delay indicator comes on.
3. Close the appliance door. The countdown
starts. When the countdown is completed,
the programme starts.
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance contin-
ues from the point of interruption.
Cancelling the delay start
Press and hold function buttons (B) and (C) at
the same time until the delay indicator goes off
and all the programme indicators come on.
When you cancel a delay start, the appli-
ance goes back to setting mode. You have
to set the programme again.
Cancelling the programme
Press and hold function buttons (B) and (C) at
the same time until all the programme indica-
tors come on.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
At the end of the programme
When the programme is completed, an inter-
mittent acoustic signal operates and the end in-
dicator comes on.
1. Press the on/off button to deactivate the
appliance.
2. Close the water tap.
www.zanussi.com