Technical Specifications - TRAPP Master 3000 Manual De Instrucciones

www.trapp.com.br
Additional Safety and Operation Instructions
Before turning on the equipment, make sure the
 
voltage of the power source (110/127 or 220/230 V)
is the same of the equipment.
Read the instructions carefully and familiarise
 
yourself with the controls and how to use the
equipment correctly.
Remember that the operator or user is responsible
 
for any accident or damage involving other
people and/or their property.
Don't operate the equipment when you're
 
wearing sandals or barefoot.
When you're using the equipment always wear
 
trousers and proper footwear.
Avoid operating the equipment in damp
 
environments and never use it in the rain.
Walk, don't run when you're using the
 
equipment.
Be careful where you step when working in hilly
 
areas - hillsides and mounds.
Always use the equipment in broad daylight or
 
good artificial light.
Turn off the equipment whenever you have to
 
cover ground and to go around obstacles.
If the equipment starts vibrating, unplug the cord
 
immediately. Check as soon as possible why it's
Motor Type
110/127 V
Single-phase
220/230 V
Induction
Three-phase 220/380 V
Extension Cord Right-use Table
Meters
Voltage
Gauge (Ø) in mm
Voltage
Gauge (Ø) in mm

Technical Specifications

Approx.
Tension Power
Rotation
1/2 cv 3600 rpm
10 m 20 m
1.0 1.5
1.0 1.5
vibrating - that's a sure sign that it needs to be
adjusted or repaired.
Check regularly if all bolts are tight. Before using
 
the equipment, check if the blade are in place.
Do a visual inspection of the cutting blade to see
that it's not damaged or blunt. Replace the blade
and damaged or worn bolts to ensure balance.
Check the cord and never use insulating tape to
 
repair it.
Never use a water jet to clean the equipment.
 
Water inside the equipment can damage the
electric circuit of the motor, besides increasing
the risk of an electric shock. Use a cloth soaked
in neutral detergent.
Warning!
Whenver you are cleaning or servicing
 
your equipment, always make sure that
it's turned off, that the blade isn't running
and unplug the cord.
Machines up to 3600 rpm currently
 
in the market shall not operate with a
spool using nylon thread. Due to low
revolution, the engine will overheat
and overload causing poor cutting
performance and engine burn-out.
Sound
Weight
Level
87 dB (A) 8.2 kg
30 m 40 m
110 / 127 Volts
2.5 2.5
220 / 230 Volts
1.5 1.5
Width
Length
(at skirt)
1.80 m 34 cm
50 m 60 m
4.0 4.0
1.5 2.5
Height
(at skirt)
13 cm
70 m
4.0
2.5
29