Breakdown - Detection And Solutions - SPIDO SPR1100 Instrucciones De Uso

EN
When disabling the pump
> Unplug the pump form the mains
> Unscrew the drainage cap (1) to empty the water in the pump
> Store the pump where it is protected from frost
Bring into service
> Follow the steps of the chapter "Getting started"
BREAKDOWN – DETECTION AND SOLUTIONS
Pump does not start?
Have you checked...
If pump is connected to the mains?
If there is no current failure of the mains?
You might need to...
Check the mains
Low flow?
Have you checked...
If connectors of the suction part are perfectly airtight?
If the filter of the pump is not obstructed?
You might need to...
Repair connections and/or change the suction hose
Clean up the filter of the pump
Pump does not prime ?
Have you checked...
Connections airtightness?
f pump positionning is in accordance with instructions (max 1m above water
level)?
If the filter of the pump is not obstructed
If the pump is full of water?
If power supply is correct?