Chain Maintenance Table; Problem Identification - Stiga CS 80 Li Manual De Instrucciones

14. CHAIN MAINTENANCE TABLE

Chain pitch
inches
3/8 Mini
0.325
3/8
0.404
The table gives the sharpening data for different types of chains,
but this does not mean you can use chains other than those approved
and listed in the "Correct bar and chain combination table".

15. PROBLEM IDENTIFICATION

PROBLEM
1. When the safety button
is pressed, the green
light does not come on
2. When the safety button
is pressed, the green light
does not come on and the
block release button flashes
3. The motor shuts down
whilst working
4. The motor stops while
working and the safety
button flashes
5. With the throttle lock button
and throttle control lever
on, the chain does not turn
6. The chain heats and
emits smoke on the
end part of the bar.
Limiter tooth level (a)
mm inches
9.32 0.018
8.25 0.026
9.32 0.026
10.26
0.031
PROBABLE CAUSE
Battery is not inserted or
is inserted incorrectly
Low battery
Battery is not inserted correctly
Low battery
Excessive chain tensioning
Bar and chain problems
Machine damaged.
Excessive chain tensioning
Lubricant oil tank empty.
a
mm
0.45
0.65
0.65
0.80
EN - 15
File diameter (d)
d
inches
5/32
3/16
13/64
7/32
REMEDY
Make sure that the battery is
inserted correctly (par. 7.2.3)
Check the battery
status and recharge if
necessary (par. 7.2.2).
Make sure that the battery is
inserted correctly (par. 7.2.3).
Check the battery
status and recharge if
necessary (par. 7.2.2).
Re-tension the chain
(par. 6.1.3).
Check that the chain runs
freely and the bar guides are
not deformed (par. 8.3, 8,4).
Do not use the machine.
Immediately turn off
the machine remove
the battery and
Contact a Licensed
Service Centre.
Re-tension the chain
(par. 6.1.3).
Fill the lubricant oil
tank (par. 7.3).
mm
4.0
4.8
5.2
5.6