Idiomas disponibles
Idiomas disponibles
t
8. Always fasten the safety harness, inserting it through
the crotch strap (G), and check that the harness fas-
tens baby correctly and that it is adjusted/tensioned
-
correctly (diag. 8).
HOW TO ADJUST THE BACKREST
9. To adjust the backrest, turn the side joints (E) (diag.
9) and recline the backrest to the desired position;
lock the joints by turning them in the opposite direc-
tion (diag.10). This operation may be carried out with
the child sitting in the bouncing chair, although it can
be more difficult. Always hold the backrest with one
hand while adjusting its position.
HOW TO ADJUST THE FOOTREST
The footrest can be adjusted to two positions.
11. Low position: Press the buttons, located on the front
joints (F), and, at the same time, push the footrest in
a downward direction. A click is heard, signalling that
it is locked into position (diag.11).
12. High position: Press the buttons and push the foot-
rest in an upward direction. A click is heard, signal-
ling that it is locked into position (diag.12).
ROCKING POSITION
The baby chair can be used in the "rocking" position.
13. Turn the rear handle (B) following the direction of
the arrow (diag.13).
14. When you wish to use the bouncing chair as a baby
chair, turn the handle in the opposite direction to
-
prevent rocking (diag.14).
e
HOW TO REMOVE THE COVER
-
The cover of the baby-bouncing chair can be removed
and cleaned.
e
15. Remove the safety harness from the "D" rings; then
.
remove the cover starting from the front, first from
n
the footrest, unfastening the Velcro straps located
-
underneath, and then from the backrest (diag.15).
e
16. To replace the cover onto the bouncing chair, repeat
the above operations in the reverse order, sliding the
g
lower fabric strap through the adjusting joints of the
-
backrest (E), as shown in diagram 16.
-
WARNING: Fit the safety harness again, checking that
-
it has been fitted correctly through the holes of the "D"
rings and the crotch strap.
t,
k
PILLOW / INSERT
6.
The comfort pillow (C) is ideal from birth, and it can be
removed at later stages of the child's growth. The soft
padding and breathable fabric ensure maximum com-
al
fort during the first months.
e
17. To fit it to the seat, insert the crotch strap (G) into
)
the correct opening of the pillow/insert, as shown in
diagram 17.
CADDY ENJOY BOUNCING CHAIR
The CADDY ENJOY range features fabrics with special
colours, which are used with a wide range of Chicco
Nursery products. For instructions on how to use the
bouncing chair, please refer to this instructions booklet,
with the exception of the "Pillow / Insert" section.
For further information or spare
parts requests, please contact
Chicco UK Ltd Customer Service:
Postal address: CHICCO UK LTD
PROSPECT CLOSE
KIRKBY IN ASHFIELD
NOTTINGHAMSHIRE - NG17 7LF
Telephone: 01623 750870
Website: www.chicco.co.uk
section "contact us"
13
