Air Circulation - Tectro TPX 32 Instrucciones De Uso

When the unit is in the dehumidifying mode, the fan speed
adjusted. The fanspeed will be automatically set on 'Medium setting'. The buttons
and can also not be adjusted.
The water which is extracted from the air is pumped to the outdoor unit through
the connection tube. Ensure that the water has a free flow outside and it is not
cause of any danger or inconvenience.

AIR CIRCULATION

In this mode the unit only circulates air; the unit will not cool or dehumidify. The
air entering the unit is not cooled or dehumidified, but is filtered.
When the unit is in this mode, the following functions apply:
• The fan speed can be adjusted by pressing the
Maximum setting.
Medium setting.
Lowest setting.
4 When the unit is switched off the most recent setting will be stored in
memory.
5 The timer function allows you to switch the unit on or off at a certain time.
TO SWITCH ON THE UNIT AT A CERTAIN TIME
• Ensure that the unit is set in the required operating mode
• Switch off the unit by pressing the
properly inserted into the wall outlet.
• Press the -button. The light "Timer set" will flash.
• Use the and
• When the set time has expired the unit will switch on.
TO SWITCH OFF THE UNIT AT A CERTAIN TIME
• When the unit is operating in the required mode press the
The light "Timer set" will flash.
• Use the and
• When the set time has expired the unit will switch off.
NOTE!
The compressor has been set so that it starts functioning three minutes
after the (re)start of the air conditioner.
The cooling will switch off when the room temperature is lower than
the set one. Air circulation will however continue to work on the set
level. When the room temperature rises above the selected value, the
cooling will work again.
-button. Ensure that the plug is
buttons to set a time between 1 and 12 hours.
buttons to set a time between 1 and 12 hours.
cannot be
-button
, of
-button.
4
57
.