Tectro TPX 32 Instrucciones De Uso página 60

CONNECTING
1
2
3
4
5
6
7
H
CLEANING
Clean the housing with a soft, damp cloth. Never use aggressive chemicals, petrol,
detergents or other cleansing solutions. For maintenance of the filters, refer to
Chapter D "Air Filter".
4
60
Pass the connection tube through the hole (at least Ø 50 mm) in the wall.
Remove the protection caps from the ends of the refrigerant tubes.
Reconnect the refrigerant tubes according to the marking (tighten the nuts
quickly to make a good seal), the drain tube and the electrical cable.
Put the isolation material around the connectors / tubing again.
Put back the metal brackets which are holding the tubes and wire.
Close the cabinet cover for quick connector shielding ¹.
Store the protection caps
WARNING
After connecting the refrigerant tubes, take care that these are well
isolated again. If this is not done properly, damage because of
condensation water can occur!
WARNING!
Switch off the unit and remove the plug from the mains before cleaning
the appliance or filter, or before replacing the filters.
NOTE!
Never use the air conditioner without screenfilter.
in a safe place.