Makita XBU02 Manual De Instrucciones página 43

— All cutter length must be equal. Different
cutter lengths prevent the saw chain from
running smoothly and may cause the saw
chain to break.
— Do not sharpen the chain when the cutter
distance between the depth gauge (round
nose) and the cutting edge.
following distance between cutting edge
and depth gauge.
30
55
the same on all cutters. Different cutter
angles cause the chain to run roughly and
unevenly, accelerate wear, and lead to
chain breaks.
sharpening angle is kept against the teeth.
for saw chains to sharpen the chain. Normal
chain is as follows:
on the return stroke.
length of this shortest cutter becomes the
standard for all other cutters on the saw
chain.
30
—
55
—
—
—
19
ENGLISH
1
2
1. File 2. Saw chain
holder (optional accessory) is employed.
parallel to the saw chain) and limits the depth
1
30
1. File holder
After sharpening the chain, check the height
of the depth gauge using the chain gauge
tool (optional accessory).
Remove any projecting material, however small,
Round off the front of the depth gauge
again.
1/5