Maintenance And Cleaning; Metal Grease-Trapping Filters - FALMEC CAPPE E-ION Manual De Instrucciones

fan will return to the 3rd speed. The intensive function is signalled by the flashing INC LED.
Note: 3 speeds are active in the SPRING model hood featuring 2 motors and the maximum
speed is not timed.
Auto: With extractor fan switched off the automatic mode will be activated/deactivated; if
activated the auto LED will be lit. In this mode, if the air quality is good, (completely green leaf)
the extractor fan and the ioniser are switched off. If the quality of the air has deteriorated, the
leaf is partially or completely yellow, the extractor fan is activated at the first speed and the
DEC LED lights up until the leaf turns completely green.
L: The brief pressure activates/deactivates the light. With the extractor fan and light switched
off, applying prolonged pressure enables the memorisation of the RF remote control. The key
flashes for a few seconds or until the remote control key is recognised.
When the extractor fan is enabled in normal functioning mode the ioniser (with increasing
power according to the level of air pollution) is also activated.
F
FILTERS
1. METAL FILTERS
To remove the metal filters, remove the lower panel fastened with one of the magnets of
the range hood. This way, the filters can be removed by using the appropriate handle.
2. COMBINED AND REGENERABLE FILTERS (qualified personnel only)
The CARBON-ZEO filters can be regenerated according to the procedures described in
paragraph H regarding maintenance. These filters are placed in the upper side of the
range hood. Follow the instructions below to remove them (see fig. F2):
- Disconnect the appliance from the mains.
- Loosen the 2 screws (V1) (4 screws for SPRING double motor range hood).
- Carefully remove the combined filter-holder (SF) (2 filter-holders for the SPRING double
motor range hood)
- Remove the filter (F) from the combined filter-holder (SF).
To order new charcoal filters, contact your distributor/dealer.
ONLY FOR ITALY: Download the filter order module from the website: www.falmec.com.
G
LIGHTING
The E-ION range hood is equipped with high efficiency, low consumption LED lighting with ex-
tremely long duration under normal use conditions. LED spotlight replacement must be carried
out only by qualified technicians and using only original material.
H

MAINTENANCE AND CLEANING

A constant maintenance ensures a proper operation and efficiency over time. Special atten-
tion must be paid to the metal grease-trapping filters, in order to prevent dangerous grease to
accumulate on the range hood, with consequent risk of fire.

1. METAL GREASE-TRAPPING FILTERS

These trap the grease particles suspended in the air; therefore, we recommend washing
them frequently (every 2/3 weeks) with hot water and detergent, preventing them from
bending. Before installing them back, wait until they are fully dried. To disassemble and
assemble them, see instructions at section F1. Operations must be performed frequently
and constantly, in order to prevent oils, greases and dust to enter inside the ionising sys-
tem.
14
REMOVING AND REPLACING'S INSTRUCTIONS