Resetting the Unit
Press the "MODE/ESC" button and choose "rEST"(restore). Press "ENTER" to confirm. The unit powers itself down
and then on again for a few seconds. During this time, the LED display will scroll "rEST" from left to right, after which
normal operation recommences.
Restoring factory defaults
Press the "MODE/ESC" button and choose "LoAD"(load). Press "ENTER" to confirm. The LED display will change to
"d001" to confirm a factory reset has been completed
Initial start-up
During the warm up time, the unit will auto test itself for a few seconds. During this time the LED display will scroll
"rEST" from left to right .The unit then start to operate normally
f- DMX Modes
The unit supports 8 and 13 channel DMX Sub-modes from a standard controller. When a suitable DMX connection is
made, the "decimal point" in "d.001" will flash.
Setting DMX Addresses
Use the "MODE/ESC" button to display "d001", "UP" and "DOWN" buttons allows individual DMX addresses to be
set from "d001" to "d512"
Choosing between DMX Sub-modes
The LED display shows the chosen control mode when the "MODE" button is pressed. Use "UP" and "DOWN"
buttons to choose the appropriated DMX control Mode
LED Display
8CH
13CH
In 8 channel mode
Channel
Function
1
PAN
2
TILT
3
DIMMER & STROBE
4
Red
5
Green
6
Blue
7
White
8
Pan/Tilt SPEED
©Copyright LOTRONIC 2018
DMX Sub-mode
8Channel
13channel
13 DMX channel mode
Channel
1
2
3
4
5
6
7
8
LMH350LED
Function
PAN
PAN FINE
TILT
TILT FINE
PAN/TILT SPEED
DIMMER & STROBE
RED
GREEN
Page 7