Details About The Mcm10 Module; Information About This Documentation; Ce Declaration Of Conformity; Intended Use - Buderus MCM10 Instrucciones De Instalación

2

Details about the MCM10 module

2.1 Information about this
documentation
Hand all enclosed documents over to the user.
Subject to technical modifications!
2.2

CE Declaration of Conformity

The design and operation of this product
conform to European Directives and the
supplementary national requirements. Its
conformity is demonstrated by the CE
designation.
The Declaration of Conformity can be
downloaded from the internet or requested
from the manufacturer. For contact
addresses, see the back cover of this
document.
2.3

Intended use

The MCM10 module is designed to control cascade
systems. A cascade system is a heating system where
several smaller boilers are connected in parallel to achieve
a higher output.
The MCM10 module is exclusively designed for the
following:
• Boilers with BUS-enabled Logamatic EMS;
• Boilers with modulating burner without operating
conditions.
MCM10
Details about the MCM10 module
2.4

Standard delivery

2
Fig. 1 Standard delivery
1 MCM10
2 Fixing materials:
- 3 screws and 3 rawl plugs
- 4 strain relief clamps and 8 screws
3 Installation instructions
B Check all components have been delivered.
2.5

Accessories

Here you will find a list of typical accessories. Contact the
manufacturer to obtain a complete overview of all
available accessories.
• Outside temperature sensor (only for system version
1).
• Flow temperature sensor (only for system versions 2, 3
and 4).
• RC35: weather-compensated heating controller with
text display for controlling a heating system with mixed
or unmixed heating circuits.
• WM10: low loss header module for EMS.
• MM10: mixer module for EMS.
2
1
3
6 720 616 691-02.1TD
57