Operation - Surgery Mode; Operation Screen Description; Perform An Operation - Bien-Air Dental Chiropro Plus 3rd Gen Instrucciones De Uso

1 2 3

8 Operation - Surgery mode

8.1 Operation screen description

FIG. 1
The Operation screen differs whether the micromotor is stopped
or running and depending on the active step.
It allows to perform an operation in 3, 4 or 5 predefined steps P1,
P2, P3, P4, P5, and displays the following information:
(1) Step P1 (active step, in green)
(2) Step P2 (inactive step, in black)
(3) Step P3 (inactive step, in black)
P4 and P5 steps are disabled by default, see " Number of steps" on
page 20 for enabling them.
(4) Speedometer
Note 1
(5) Contra-angle ratio
Note 2
(6) Operation settings symbols
See chapter "9 Settings" on page 18 for details on adjusting settings.
16
4 5
6
FIG. 1
1

8.2 Perform an operation

FIG. 2
A. Operate by pressing the footpedal to adjust the MX-i LED
micromotor speed.

Inactive steps symbols turn off when the motor is running.

Speedometer displays real-time speed value in black.
Note 3 - 4 - 5
FIG. 3
B. If necessary, release the footpedal to perform the following actions:

Speedometer (1) displays the set micromotor maximum
reachable speed in cyan.
• Turn the knob CW or CCW to respectively increase or
decrease the micromotor maximum reachable speed (quick
setting mode).
Note 6

The speedometer is cyan and displays the set micromotor
maximum reachable speed (1).
Note 7
• Long press on the knob to change operation settings.

The Settings mode is displayed.
See chapter "9 Settings" on page 18 for details.
C. Short press on the footpedal's orange button or on the knob to go
to the next step.

The next step symbol turns green and the step's last used
settings are restored.
Note 5
FIG. 2