Power Switch - Peavey PV 10 Manual Del Operador

Rear Panel
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, THIS APPARATUS
CAUTION
SHOULD NOT BE EXPOSED TO RAIN OR MOISTURE AND OBJECTS FILLED WITH LIQUIDS,
SUCH AS VASES, SHOULD NOT BE PLACED ON THIS APPARATUS.
AVIS:
DANS LE BUT DE REDUIRE LES RISQUES D'INCENDIE OU DE DECHARGE
ELECTRIQUE, CET APPAREIL NE DOIT PAS ETRE EXPOSE A LA PLUIE OU A L'HUMIDITE ET
AUCUN OBJET REMPLI DE LIQUIDE, TEL QU'UN VASE, NE DOIT ETRE POSE SUR CELUI-CI.
POWER
ON
100 - 240V 50/60Hz
27 WATTS
42 43

Power Switch

42
Depressing the power switch supplies power to the unit.
Warning: The power switch in this unit breaks only one side of the line. Hazardous energy may be
present inside the mixer when the power switch is in the OFF position.
Removable Power Cord
43
This receptacle is for the IEC line cord (included) that provides AC power to the unit. Connect the line
cord to this connector and to a properly grounded AC supply. Damage to the equipment may occur if an
improper line voltage is used (see voltage marking on unit). Never remove or cut the ground pin of the
line cord plug. The console is supplied with a properly rated line cord. If lost or damaged, replace this
cord with one of the proper rating.
NOTE FOR UK ONLY:
If the colors of the wires in the mains lead of this unit do not correspond with the colored markings iden-
tifying terminals in your plug, proceed as follows: (1) The wire that is colored green and yellow must be
connected to the terminal marked by the letter E, or by the earth symbol, or colored green or green and
yellow. (2) The wire that is colored blue must be connected to the terminal that is marked with the letter
N, or colored black. (3) The wire that is colored brown must be connected to the terminal that is marked
with the letter L or colored red.
USB port and USB Record Level Control
44
The USB port is used to connect the PV™ Series USB mixer to
acomputer for recording or playing back digital audio to/from
your computer. The USB port sends the mixer's main/tape
stereo out to the computer. The amount of the main mix
signal being sent to the USB port can be adjusted using the
Record Level control located next to the USB port. The USB
port receives digital audio from the computer; it can then be
assigned through the "Tape/USB to Mix" switch (27) to the
main left/right output. The USB input level is controlled by
the computer volume control.
Compatible with Windows
with Mac OS X
peavey.com
A PRODUCT OF
PEAVEY ELECTRONICS CORP.
DESIGNED IN USA MADE IN CHINA
XP, ME & 2000. Also compatible
®
®
10.0 or later.
INPUT
1 - GROUND
2 - POSITIVE
3 - NEGATIVE
OUTPUT
1 - GROUND
2 - POSITIVE
3 - NEGATIVE
1
INPUT BALANCED TRS INSERT
SLEEVE
1 - GROUND T (POS)
2 - POSITIVE TIP
R (NEG)
3 - NEGATIVE
S (GND)
RING
OUTPUT UNBALANCED
TIP = SND
1 - GROUND
T (POS)
RING = RET
2 - POSITIVE
SLEEVE = GND
3 - NEGATIVE S (GND)
DIGITAL AUDIO
PORT
MIN
COMPUTER
RECORD
LEVEL
BALANCED TRS INSERT
SLEEVE
T (POS)
TIP
R (NEG)
S (GND)
RING
UNBALANCED
TIP = SND
T (POS)
RING = RET
SLEEVE = GND
S (GND)
DIGITAL AUDIO
PORT
MIN
COMPUTER
RECORD
LEVEL
44