Velleman CAMCOLVC10 Manual Del Usuario página 6

•
Shortly press the control button [D] 2 times to stop recording and return to
standby mode. The status LED [C] lights up blue.
• In standby mode, press the picture button [F] shortly to take a picture. The
status LED [C] will light up red, then returns to blue.
•
To switch off the camera, press and hold the video button [D]. The status
LED [C] flashed 3 times red.
Note: the camera will switch off automatically when the memory is full.
•
To reset the camera, press and hold the picture button [F] and press the
video button [D] simultaneously.
Connecting to USB port
• Remove the cover of the USB port [E] and plug the jack of the included USB
cable into the port. Plug the other end into a suitable powered USB port.
The status LED [C] turns red + blinking blue during charging or blue when
battery is full.
• The watch now acts as a removable storage medium. Browse it and open
the AVI‐files with a suitable player.
• To set the date/time stamp of the camera, locate the file
WriteTime_En.exe on the included CDROM and double click it. The time
and date setting of the computer are copied to the camera.
Note: this file can also be downloaded from www.velleman.eu.
• Always place the USB cover back after using the USB port.
Adjusting the wristband
Refer to the illustration on page 3 of this manual.
•
First determine the appropriate size of the wristband. Count how many
links should be removed.
•
[1] Use a small screwdriver to push the protrusion on the link next to the
clasp down and away from the wristband (see arrow on image).
•
[2] Pull out the pin completely.
•
[3] Slide the link over the connection plate.
•
Count the number of links to be removed and repeat the above procedure
[1‐3].
Note: it is better to remove e.g. 2 links on either side of the clasp than 4
links on one side and none on the other.
•
Hook the last link back over the connection plate.
•
Re‐insert the pin. Make sure it does not stick out of the wristband.
•
Small changes in wristband size can be achieved by moving the clasp itself.
Use a small object (e.g. an unfolded paperclip) to gently press on the
flanged spring bar. Re‐insert the spring bar on one side into the desired
location, press the flange on the other side of the bar down and move the
wristband until the spring bar snaps into place. Make sure the spring bar is
in the same position on both ends.
10/09/2010
CAMCOLVC10
6
Rev. 01
©Velleman nv