Air Conditioner Use; Starting Your Air Conditioner; Changing Air Direction; Normal Sounds - Haier HWF05XCK Manual De Uso

Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
If you turn off the air conditioner, wait at least 3 minutes before
turning it back on. This keeps the air conditioner from blowing a
fuse or tripping a circuit breaker.
POWER
Turn air conditioner on or off.
SPEED
LOW
Low speed fan operate with optional cooling.
HIGH
High speed fan operate with optional cooling.
This automatically controls the temperature of indoor air.Turn
the knob so that the arrow points to the cooler marks for more
moderate cooling.
Normal Fan
1. Turn the SPEED mode switch to the "HI" or the "LOW" setting.
2. Set the thermostat control to the "FAN ONLY" setting .
Normal cooling
1. Turn the SPEED mode switch to the "HI" or the "LOW" setting.
2. Set the thermostat control to the desired temperature.(The
mid-point is a good starting position .)
If the room temperature is not satisfactory after a reasonable
time,adjust the control to a cooler setting,as appropriate.

AIR CONDITIONER USE

Do not try to operate your air conditioner in the Cool mode when
outside temperature is below 65°F (18°C). The inside evaporator
coil will freeze up, and the air conditioner will not operate
properly.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.

Starting Your Air Conditioner

Maximum cooling
1. Turn the SPEED mode switch to the "HI" setting.
2. Set the thermostat control to the MAX COOL temperature
mark.
Quieter operation
1. Turn the SPEED mode switch to the "LOW" setting.
2. Set the thermostat control as needed.
When your air conditioner is operating normally, you may hear
sounds such as:
Droplets of water hitting the condenser, causing a pinging or
clicking sound. The water droplets help cool the condenser.
Air movement from the fan.
Clicks from the thermostat cycle.
Vibrations or noise due to poor wall or window construction.
A high-pitched hum or pulsating noise caused by the modern

Changing Air Direction

A. Tab

Normal Sounds

A
9