Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ENGLISH
DIFFERENTIAL TEMPERATURE
1. When two K-Type thermocouples are attached to the meter,
the main display will show T1 temperature and the secondary
display will show T2 temperature. Insert one K-type thermo
couple into port T1 and another into port T2.
2. To measure the differential temperature press the "SEL" button
and the T1-T2 icon will be displayed. The main display will
9
show the differential temperature value.
3. Press the SEL button
TEMPERATURE CALIBRATION
1. Remove leads from meter and slide the temperature probe input
switch
to close jacks and expose the K-Type thermocouple ports.
18
2. Insert K-type thermocouple into ports
markings on thermocouple and meter), and rotate function
selector switch
3. Long press the MAX/MIN button
at the same time. The meter will beep, and the CAL icon will
appear on the secondary display and the main display will have the
temperature measurement.
NOTE: In T-CAL mode, the T1 and T2 channels can be selected for
calibration by pressing the SEL button
can be changed by a long press to the SEL button
4. Place the K-Type thermocouple in a known temperature system
(eg. ice water, boiling water, or other standard temperature
source) and allow to stabilize.
5. Utilize the RANGE button
the REL/LPF button
the correct value, the T-CAL icon will appear on the display and
it will remain on the screen to designate a user calibration.
NOTE: To clear calibration data, long-press the HOLD
default to factory temperature calibration. The T-CAL icon will be
removed from the display.
6. To exit the calibration mode, long-press the MAX/MIN
and the V+A/Inrush button
16
OPERATING INSTRUCTIONS
again to exit differential temperature.
9
to the Temperature
2
7
to decrease the value. Once adjusted to
11
10
(observe polarity
17
setting.
and the V+A/Inrush button
8
, and the °F and °C units
9
to increase the measured value and
at the same time.
.
9
button to
6
button
8
10
Tabla de contenido
