Tool Lubrication - Bosch TG502 Instrucciones De Funcionamiento Y Seguridad

The tool is not designed for water and electric
shock may occur.
1. Before running a cut-off machine, inspect
the cutting wheel for chips or cracks. Re-
place bad wheels immediately. New wheels
should be run in at no load for at least a
minute in the direction away from the pres-
ence of other people. Imperfect wheels will
normally break apart during this time.
2. An abrasive cut-off machine must NEVER
be operated without the attached guard se-
curely in place. The guard should be rotated
into the position where maximum protection
is provided for the operator from sparks and
wheel periphery.
3. Proper apparel for operating the tool in-
cludes eye protection, leather gloves and
dust mask.
4. With the tool in the "OFF" position, become
familiar with handling the tool. Control the
head of the tool with the side handle. Con-
trol the cutting edge of the wheel with the
switch handle. Always use both hands when
operating the tool.
SERVICE
Preventive maintenance performed by un-
au thorized personnel may result in mis- placing of internal wires and components
which could cause serious hazard. We
recom mend that all tool service be performed
by a Bosch Factory Service Center or Autho-
rized Bosch Service Station. SERVICE MEN:
Disconnect tool and/or charger from power
source before servicing.

TOOL LUBRICATION

Your Bosch tool has been properly lubricated
and is ready for use.
1600A003P6 08-14.indd 12
Do not use water when
cutting with this tool.
Maintenance
NO USER SERVICE-
ABLE PARTS INSIDE.
5. Never drop the tool. Set the tool down gen-
tly, but never on the wheel.
6. CUTTING CONCRETE will throw large
amounts of dust into the surrounding area.
Protective dust masks are required for
breathing protection for the operator and
other nearby workers.
7. It is not recommended to use this tool over- head or in any position that would not allow
proper control. Ladders are not considered
solid support structures.
8. Avoid overloading tool. Do not allow the
wheel to bind or stall. Many cuts, espe-
cially into solid concrete, require successive
passes. Do not expose any more abrasive
wheel than necessary to cut with normal
amount of pressure applied to tool. Begin
cutting from the edge of the material, only
plunging to a depth of one diamond wheel
segment. Cutting too deeply at one time
does not allow dust to clear fully and erodes
/thins body of wheel. Do not force the tool;
load it normally. Depending on material
hardness and density, make successively
deeper passes until cut is complete.
CLEANING
To avoid accidents, al-
tool and/or charger from the power supply
before cleaning. The tool may be cleaned most effectively with com pressed dry air. Al-
ways wear safety goggles when cleaning
tools with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed ob-
jects through opening.
Certain cleaning agents
and
plastic parts. Some of these are: gasoline,
car bon tetrachloride, chlorinated cleaning sol-
vents, ammonia and household detergents
that contain ammonia.
12
ways disconnect
solvents damage
8/13/14 2:22 PM
the