Neckstrap Attachment - Bushnell ENGAGE Manual De Instrucciones

7. Once the diopter adjustment ring is set for your eyesight, push the ring back down to lock it in place (Fig. 4,
"LOCKED").
8. Your binocular should now be adjusted for your eyes. Focusing for any distance can now be done simply by
turning the center focus knob. Make a note of your diopter setting (position of red index mark on diopter ring
relative to plus and minus marks below the ring) for future reference.

Neckstrap Attachment

To attach the neckstrap, thread the ends of the neckstrap through the strap
lug (Fig. 5) on each side of the binocular (start at the bottom of the channel
and push the strap up through the top as shown), then back through the
plastic buckle on the strap (Fig. 6). Adjust the position of the binoculars
on your chest as they hang around your neck to your preference, by
changing the length of the strap section which passes through the strap
channel and buckle by an equal amount on each side. If you prefer to use
an aftermarket strap that has metal O-rings, attach them to a plastic zip
tie placed on the strap lugs rather than installing them directly on the lug,
to avoid damaging the finish on the binocular via contact with the rings.
Objective Lens Covers
When using your Engage binoculars, flip open the objective lens covers
(Fig. 7). To prevent accidental loss, the covers are tethered to (removable)
rubber security rings. When you are finished using the binoculars, put the
covers back in place to protect the binocular's lenses.
Fig. 6 Strap & Buckle
Fig. 5 Strap Lug
Fig. 7 Objective Covers
7