Information In The Main Window; Selecting And Configuring Parameters; Viewing And Handling The Controller; Configuring Weekly Programming - S&P PROGRAM Instrucciones De Uso

4. INFORMATION IN THE MAIN WINDOW

Fan speed (%)
Te
Outdoor probe
Tx
Expelling probe
By-pass
The icon for closing the window is always at the top left/hand of the
screen. To move to the next screen, rotate the switch until you reach the
icon and then press the button.
Operation status is summarised on the main window, although the user
can chose a simplified window.

5. SELECTING AND CONFIGURING PARAMETERS

MAIN WINDOW
1
2
SIMPLIFIED WINDOW
1
1. Fan speed
When the icon is selected, it is possible to change fan speed by
turning the switch.
If the fans are three phase, the speed will vary from 0% to 100%
in 5% steps and will appear on the display. If the fans are 3-speed,
the display will show: 1, 2 or 3.
If you select Timer, speed will be set automatically from the es-
tablished weekly time programme. If you select Auto, speed will
be set automatically according to the quality of the extracted air
Fan rotation Battery stage
(stationary, 1 or 2)
5
4
3
5
4
3
5 sec.
and the comfort profile selected (See section 6.5.1. COMFORT
CONFIGURATION).
2. Timer/booster function
When you select the timer icon, the clock will begin to count down
and the fans will work at 100% speed until the time is over. By
default, the timer works for 10 minutes, if you want a different time,
Tr just turn the switch to the desired time.
Return probe
3. Set temperature
Selecting the temperature setting icon, you can change the desired
temperature at the entrance of the premises. (Note that this icon is
only enabled if you have a post-heating battery).
4. Alarm on
When an alarm comes on, the ALARM signal in the window is acti-
vated. On the console, a flashing red light and on the viewing panel
the message Call Services is displayed. The alarm may indicate
that the filters are dirty or other types of problems.
5. Close window
On all screens, this icon can be used to close the current screen
and go to the previous one. To go to a simplified window, press the
button for more than 5 seconds.

6. VIEWING AND HANDLING THE CONTROLLER

6.1. CONFIGURING WEEKLY PROGRAMMING

8
On the Menu screen, select Program
From this window you can configure
the three speeds: low, medium and
high, which will be used as referen-
ce for the daily programming. In this
case, the values are:
Low speed: Off (stationary)
Medium speed: 40% (of the maxi-
mum speed)
High speed: 65% (of the maximum
speed)
This window offers a graphic display
of the programming for the seven
days of the week. Each bar stands
for a time interval for the day and
its height represents the 3 possible
speeds (slow, medium and high).
This window provides information for
each day and time interval. From this
window you can configure the time
an interval starts, fan speed and swit-
ching the post-heating on/off. Note
that the last interval ends at 23:59 of
the same day.
At the end, you can choose the Co-
pyDay option to copy data from ano-
ther day of the week.
This window provides information for
each day and time interval. From this
window you can configure the time
an interval starts, fan speed and swit-
ching the post-heating on/off. Note
that the last interval ends at 23:59 of
the same day.