Using The Remote Controls; Adjusting The Air Flow - Technibel MCW Instrucciones De Uso

5 - USING THE REMOTE CONTROLS

5.1 - MANUAL OPERATING MODE INVERSION CONTROL (70250076)
1 - Operating switch with fan speed selection.
2 - Temperature setting knob.
3 - Operating mode selector switch.
Heating
Cooling
Caution: Before selecting the operating mode, make sure that the temperature of the
water in the installation corresponds with the mode required. If not, the thermostat
cannot ensure its operation correctly.
5.2 - AUTOMATIC OPERATING MODE INVERSION CONTROL
(70250051)
1 - Operating switch with fan speed selection.
2 - Temperature setting knob.
3 - Cooling on indicator light.
4 - Ventilation on indicator light.
Note: When this light is flashing it means that the fan is currently shutting down.
5 - Heating on indicator light.
Caution: With this control, Heating/Cooling mode selection is made automatically.

6 - ADJUSTING THE AIR FLOW

6.1 - HORIZONTALLY
• The air flow can be adjusted horizontally
by moving the vertical fins to the right or to
the left.
• In cooling operation, do not turn the fins
completely to the left or right. Doing so
may cause condensation to form which
could fall to the floor.
6.2 - VERTICALLY
• The flow of air can be regulated by moving
the flap upwards or downwards.
• In cooling mode, do not direct the damper
downwards more than 30° so as to avoid
the formation of droplets of condensation
which could fall on the floor.
6.3 - RECOMMENDED POSITION FOR THE DAMPER
MCW
Area "A"
for cooling
30¡
LEFT
Vertical fins
UPWARDS
Damper
DOWNWARDS
Air inlet grilles
Area "B"
for heating
60¡
"B"
MCW
RIGHT
RIGHT
LEFT
KPSW
MCW
UPWARDS
DOWNWARDS
KPSW
"A"
Area "A" for cooling
"B"
Area "B" for heating
1
3
2
5
4
3
1
2
KPSW
"A"
"B" 30¡
3
F
GB
I
E
D