Airwell FAV012 Manual De Instrucciones página 29

Installation Procedures
3.Floor Type Installation
*Fix four rubber feet to the bottom of the unit with
and 12 spacers (applicable to floor type units only).
*According to figure on the right, choose a certain direction to
lead out drain pipe; drain holes are available on both right and
left sides; practical conditions shall be considered. After deciding
upon the directions to lead out pipelines, wires and drain pipes,
drill wall holes according to required drilling processes.
Left Side Right Side
Drain Hole Drain Hole
Figure 4 Model FAV012, FAV024
*Install wall mount rack according to figure below.
990mm
500mm
65mm
Wall Hole
35mm
*
125mm
Model FAV012, FAV024
*Installing Drain Pipe
In case of model 12-24, fix drain pipes to drain holes on left and right sides (as shown in figure 4
and figure 5).
Install as follows (see figure below):
Plug drain pipe in water pan in the first place, as shown by figure, then, bind the two tight together
and tie up junction area with heat insulant.
Drain Pipe
245mm
Ceiling Mount Rack
Edge
70mm
100mm
Water Pan
Bond
Drain Pipe
21
4X16 bolts
Downwards
Water Pan
Heat Insulant
Backwards