Makita DJN161 Manual De Instrucciones página 7

Always replace the punch and die as a set. To remove
the punch and die, loosen the lock nut with the wrench.
Remove the die holder from the tool. Use the hex
wrench to loosen the bolts which secure the die.
Remove the die from the die holder.
Use the hex wrench to loosen the screw which secures
the punch. Pull the punch out of the punch holder.
1
2
3
► 1. Punch 2. Punch holder 3. Screw 4. Hex wrench
5. Loosen 6. Tighten
To install the punch and die, insert the punch into the punch
holder so that the notch in the punch faces toward the
screw. Tighten the screw to secure the punch. Install the die
on the die holder. Tighten the bolts to secure the die.
► 1. Punch 2. Notch
Then install the die holder on the tool so that the punch
is inserted through the hole in the die holder. Tighten
the lock nut to secure the die holder. After replacing the
punch and die, lubricate them with machine oil and run
the tool for a while.
1
2
3
► 1. Bolts 2. Die 3. Punch 4. Die holder
5
6
4
1
2
4
OPERATION
Pre-lubrication
Coat the cutting line with machine oil to increase the
punch and die service life. This is particularly important
when cutting aluminum.
Cutting method
Hold the tool so that the cutting head is at a right angle
(90°) to the workpiece being cut. Move the tool gently in
the cutting direction.
Cutouts
Cutouts can be done by first opening a round hole over
21 mm (13/16") in diameter which the cutting head can
be inserted into.
7 ENGLISH