Changing The Assembly Location - Nussbaum SPRINTER MOBIL 2500 Instrucciones De Servicio

Ocultar thumbs Ver también para SPRINTER MOBIL 2500:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

5 Oil filling opening
• Fill new hydraulic oil (e.g. HLP 32). About 8 litres
are needed.
• Provide an on-site electrical connection of 3 ~/N
+ PE, 400 V, 50 Hz, fuses with 16 A, slow.
• Connect the electric cable to the customer-pro-
vided mains breaker (e.g. a Cekon plug).
• Turn on main switch (2) and press the „LIFT" button
(3).
If the lift does not move upwards after a few sec-
!
onds, the direction of rotation of the motor is in-
correct. Swap 2 phases on the plug.
• Then press the „LIFT" button (3) again and raise
and lower the lift to its limit positions several times
without load. This will largely ventilate the hydrau-
lic system.
8.3

Changing the assembly location

• To operate the lift, it must be raised about 500 mm
so that the back wheel axes (9) and guide roller
(6) can be engaged.
8
7
6 Guide roller
7 Torsion shaft
8 Towing bar
66
5
026
003
9
6
illustration similar 004
9 Wheel axles
• Place the guide rollers (6) over the torsion shafts
(7). Then push them until the tappet (10) is locat-
ed in the notch (11) of the guide roller.
6 Guide roller
10 Tappet
11 Notch
• The wheel axles (9) are in the lower plate of the
lift (12).
9
9 Wheel axle
12 Wheel axle storage
To simplify mounting, it may be necessary to
i
raise or lower the lift a little.
• Then lower the lift completely. Hang the tow bar
(8) into the guide roller (6) and the lift can then
be moved.
• To remove the roller, follow the instructions in the
reverse order.
• The mobile hand unit quickly makes the SPRINTER
MOBIL - HYMAX PRO ready to use again.
• To change the setup location of an anchored lift,
the conditions according to the setup guidelines
in Section 4.1 must be ensured.
Use new anchors. The old anchors are no longer
!
fit for purpose!
OPI_SPRINTER MOBIL 2500-3000_V3.1_DE-EN-FR-ES-IT
19
6
11
10
19 Guide roller holder
12
005
019
Tabla de contenido
loading

Este manual también es adecuado para:

Sprinter mobil 3000Hymax pro 3000Hymax pro 2500

Tabla de contenido