Fermax DUOX Serie Manual De Instalador página 13

When mapping, the amplifi er saves the link between the natural call code (address) and the newly
assigned call code in a table.
There are 2 ways of carrying out mapping:
1. Inverse Programming.
If you need the buttons to generate non-sequential calling codes, like for codes that include fl oor
num. and house number.
2. Sequential Programming.
If you need a special distribution. On street panels you press the call buttons in the order in which
you want to associate the codes, starting with 0 and then sequentially until the last one.
Important notes:
• Programming is always done from the panel activated as MASTER.
• The panel must be previously confi gured as Master if you want to do inverse or sequential programming.
• In order to enter in any button mapping mode you must have the amplifi er in stand-by.
MASTER Panel:
• A street panel is confi gured as a MASTER via the SW1 amplifi er button. If the SW1 button is pressed 3 times quickly, it
is activated as a MASTER panel and a confi rmation tone sounds (beep-beep).
• When a panel is selected as MASTER, it notifi es the rest of the situation and if another was previously confi gured, it
would automatically stop being so.
• If there are various blocks in an installation, we recommend using the general entrance panel as MASTER since it allows
you to program all of its telephones.
• Once having completed the terminal´s confi guration, we recommend deactivating the MASTER panel to avoid accidentally
reprogramming terminals.
• The panel deactivates itself from master mode following the same activation procedure: 3 quick presses of the SW1
button. A deactivation tone sounds (bop).
Amplifi er
SW1
DL1
DUOX
CN9 TAMPER
DL1
CN1 PACK EXTENSION
TYPE Nº
JP1
EG
JP2
BK
BK
SB
SW1
CN1
Nº PL
SW1 PROG
JP1 LEDS
ON OFF
LINE
JP2
ADAPTOR
C OFF
ONE
TO
BUS
ONE
B B C
CN2 CN3 P2 NO NC
NC
ALIMENTACION
POWER SUPPLY
- + 18 Vdc
NO
AMPLIFICADOR
VIDEO
AMPLIFIER
A
AUDIO
B
C
D
E
F
IDIOMA
LANGUAGE
EXIT
18Vdc
- S + GND
2 1 BS CT P1 +
VERSION
:
C
5
DUOX