Troubleshooting - Imetec N5001 Instrucciones De Uso

Position the ON/OFF switch (5) to turn the product OFF.
Unplug the power supply cable with plug (7) from the socket.
Wait until the iron cools down completely.
Remove any starch deposits or residue on the surface of the base of the iron (12) with a damp cloth and
non-abrasive liquid detergent.
Clean plastic parts with a damp cloth.
Then wipe with a dry cloth.
STORAGE
Fold the mono-tube (10) in half, with the iron resting on its stand (9) [Fig. C].
Insert the folded mono-tube into the recess (4), sliding it inside the special clamp.
Slide the mono-tube (10) along the entire cable recess (4).
Insert the mono-tube (10) behind the second clamp [Fig. D].
WARNING! Risk of fire. Wait for the appliance to cool
completely before storing it.
This chapter describes the most common problems that can arise using the appliance. If the problems
cannot be solved with the information below, please contact the Authorised Assistance Centre.
Problem
Scale on the wave
plate.
There are small marks
or little cracks on the
plate.
The plate (12) remains
cold or does not heat
up.
The plate temperature
LED (11) goes on and
off.

TROUBLESHOOTING

Possible cause
Scale has deposited after the
iron has been used.
The appearance is the result
of the special hard anodised
surface.
There is no power
supply.
Normal procedure.
Solution
Let the iron cool down, then clean the
plate with an abrasive sponge (of the type
for cleaning dishes).
This is a special product feature, that
makes the plate highly resistant to
scratches.
Check if the power supply cable plug (7)
is inserted correctly or try inserting it in
another socket.
The plate temperature control LED (11)
switching ON and OFF indicates the
heating phase of the iron. The LED goes off
once the set temperature is reached.
EN
21