Ottobock 6A30-10 Instrucciones De Uso página 9

• Use a rasp to flatten the distal end of the plaster positive to obtain an even
surface for the dummy plate (5).
• Secure the dummy plate with the four screws provided with the kit (fig. 2).
• Pull over a 99B81 PVA Bag. Tie off distally in the groove of the dummy
plate and cut off.
• Apply silicone grease to the thread of the short dummy for the ratchet unit
(7) and insert it in the shuttle lock housing.
• Place the shuttle lock housing (2) with the dummy sleeve (4) and secure
with the screw with the dummy plate (5) (fig. 3).
Note: For trial fitting, slightly grease the thread of the ratchet unit
(3) with 633F11 Silicone Grease.
• Degrease the ratchet unit (3) and the shuttle lock housing, secure it
using 636K13 Loctite and screw it into the shuttle lock housing. Tighten
using 710D4 Torque Wrench. Torque: 20 Nm.
Caution!
Improper tools may damage the ratchet unit or impair its function!
Never use an open-end wrench for unscrewing and retightening.
Use only the tool indicated in the Instructions for Use.
Use the following tools:
• 710D4 Torque Wrench
• the suitable 709S26=1/4"×1/2" adapter piece and
• the S6A20-2 Socket Wrench Kit.
Caution!
Improper tools may damage the push button!
To remove the push button from the ratchet unit, please use a screw
driver with 2 mm tip or a coin of comparable thickness.
Whenever grinding inside the socket, protect the shuttle lock from dirt by
sealing the lock opening with tape or a piece of clean cloth.
Please find further processing instructions in the Technical Information 2.1.6.
Secure the Pin with Loctite 241 (636K13), screw it into the liner's thread
and tighten to 3 Nm (2.2 lbf.ft., 27 lbf.in.) using the 710D1 Torque Wrench
or equivalent.
Ottobock | 9