Installing The Faucet - Transform QL035 Manual Del Usuario

Installation (continued)

INSTALLING THE FAUCET

- Unscrew the retaining ring (16) from the bottom of the body base
(11), ensuring that the gasket (14) and washer (15) are removed
with the retaining ring .
- Place the lower part of the body base (11) through the hole in the
sink .
- From underneath, slide the gasket (14), washer (15), and the
retaining ring (16) until in correct position .
- Tighten the retaining ring (16) by hand, until it is snug .
- Using a wrench or pliers, tighten the entire assembly .
- Gently tighten the two screws (17) on the retaining ring . DO NOT
OVERTIGHTEN .
- Attach the end of the hose with the small fitting (18) onto the
faucet outlet (20) and hand tighten . Then, using one wrench on
the hexagonal nut of the faucet outlet and another on the hose
nut, tighten the two ends together . Tightening with just a single
wrench may deform the nut on the hose .
- Install the counterweight (19) on the hose about 432 mm (17 in .)
from the underside of the faucet . This can be adjusted based on
your own requirements .
- Screw the sprayer head (1) onto the end of the hose (4) .
- Attach the lever (13) to the handle base (12) .
NOTE:
Please ensure that the flexible risers included in the faucet are not kinked or
forced during installation.
9
11
432mm
(17 in .)
19
7
Please contact [email protected] or 1-877-333-0098 for further assistance .
8
7
13
12
14
15
16
17
20
18
CONGLOMKB .COM
6
5
4
3
2
1