Tabla de contenido
Idiomas disponibles
Idiomas disponibles
(Figure 29)
need to change any part involved in this circuit, proceed as
follows:
Open the protective pneumatic components cover as explai-
F
ned in section 8.2.
Loosen the filler cap F (Fig. 29) and with the aid of a funnel
fill the tank to approximately ¾ full.
Replace the sealing cap and fit the motor cover.
CAUTION
Only use oil for hydraulic circuits.
9.
After each operating cycle, carefully clean the machine and
all its parts, vacuuming any shavings and dust.
Use compressed air only when it is truly necessary, wearing
protective goggles and a face mask.
Keep clean, removing any shavings from the work bench.
10.
The safety of the machine is a direct result of the effective-
ness of the safety devices used.
Inspect the following devices once every two weeks:
• Make sure that the safety microswitches described in sec-
tion 2.4 work correctly.
• Ensure that the motor stops when the operating pedal is
released.
11.
GENERAL CLEANING
Eliminate the pressure from the installation by
disconnecting the safety valve and locking it
with a padlock, then setting the main switch to
0 (zero), locking it with a padlock.
INSPECTING SAFETY DEVICES
SCRAPPING THE MACHINE
This operation must be performed by expert
operators, while respecting current laws re-
garding workplace safety. Do not dispose of
non-biodegradable products, lubricating oils
or non-ferrous components (rubber, PVC, re-
sins, etc.) into the environment. The destruc-
tion must follow current laws in this regard.
PAE85T / Operating instructions - 45
Capítulos
Tabla de contenido
