Evolution EVOSAW180HD Manual De Uso página 18

Fig. 10
Fig. 11
Chip Collector
This machine is fitted with a Chip Collector to capture
metal chips. The Chip Collector cover plate is provided with
a transparent 'window' so that the operator can see the
contents and empty when necessary.
WARNING: The Chip Collector is very efficient and must
be checked and emptied at regular intervals.
When cutting steel the Chip Collector can become hot.
Care must be taken when handling the Chip Collector.
To remove and empty the Chip Collector:
• Loosen the two Chip Collector thumb screws. (Fig. 10)
• Ease the Chip Collector from the machine.
• Empty the contents of the chip collector by tipping the
collector upside down over a suitable waste container,
allowing the contents to fall out.
Note: To maintain operational efficiency we recommend
that the collector is emptied when approximately 60%
full. Dispose of the contents of the chip collector in an
environmentally responsible manner.
• Replace the Chip Collector and securely tighten the two (2)
thumb screws.
Discharge Port
When cutting lumber the Discharge Port Exhaust should be
fitted to the Discharge Port on the Chip Collector.
To fit the Discharge Port Exhaust:
• Remove the Discharge Port cover by unscrewing the cross
headed screw.
• Pull the cover from the Discharge Port and store safely for
future use.
• Fit the Discharge Port Exhaust in place of the blanking cover.
(Fig.11)
Wood chips will be ejected from the Discharge Port Exhaust
during lumber cutting operations.
• When cutting has been completed, remove the Exhaust
Port and replace the cover and tighten the fixing screw
securely.
18
www.evolutionpowertools.com