Evolution EVOSAW180HD Manual De Uso página 16

Fig. 4
Fig. 5
(b)
(a)
Fig. 6
• Ensure that the direction of rotation arrows printed on the
blade match the direction of rotation arrow found on the
chip collector. (Fig. 4)
• Reinstall the outer drive flange and the arbor socket
headed screw.
• Engage the arbor lock and tighten the arbor socket headed
screw securely using the hex key.
• Replace the chip collector and securely tighten the
two thumb screws.
• Check that the arbor lock is fully released by manually
rotating the blade.
• Check the operation of the lower blade guard.
Parallel Edge Guide
A parallel guide (for help when rip cutting) can be fitted to the
base plate of the machine. The guide's arms should be inserted
into the rectangular slots in the turned up edges of the sole
plate, and slid under the locking thumb screws. (Fig. 5)
Note: The parallel edge guide can be fitted to either side of
the sole plate and should only be fitted and adjusted with the
machine disconnected from the power supply.
Adjust the parallel edge guide so that it is at the required
distance from the blade and tighten the two thumb screws.
Check that the parallel edge guide is parallel to the saw blade.
Auxiliary Handle (Fig. 6)
The Auxiliary Handle (supplied) can be screwed into a threaded
boss found to the front left hand side, slightly above the
machine's motor (b), or into the boss found on the bevel
locking quadrant (a).
This handle will provide the operator with a convenient position
for their left (or right) hand during cutting operations.
16
www.evolutionpowertools.com