Operating Instructions - Evolution EVOSAW180HD Manual De Uso

www.evolutionpowertools.com
Adjustment of the Cutting Depth
Release the lever lock (Fig. 7) to adjust to the required cutting
depth. Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth of the blade teeth should be
visible below the workpiece.
Note: Always check to see if there are any obstructions below the
work surface that could influence the setting of the cutting depth.
Tighten the lever lock securely to lock in the required position.
Adjustment of the Cutting Angle
• Loosen the bevel locking screw found at the front of the saw.
• Loosen the rear bevel locking screw found at the rear of the
machines sole plate.
• Tilt the saw body to the required angle (Fig. 8).
• Tighten both bevel locking screws securely.
Note: An angle scale (0
– 45 ) is incorporated into the bevel
0 0
locking quadrant to aid setting.
OPERATING ADVICE
Carry out routine safety checks each time you use the machine.
Check that all safety guards are operating correctly, and that all
adjustment handles/screws are tightened securely.
Check that the blade is secure and installed correctly. Also check
that it is the correct blade for the material being cut.
Check the integrity of the power cord.
Always clamp the workpiece to a rigid support such as a bench
or saw horse whenever possible.
ON/OFF Trigger Switch (Fig. 9)
This machine is equipped with a safety start trigger switch.
To start the machine:
• Push in the safety lock button on the side of the handle with
your thumb.
• Depress the main trigger switch to start the motor.
WARNING: Never start the saw with the cutting edge of
the saw blade in contact with the workpiece surface.
Fig. 7
Fig. 8
Fig. 9
17
EN
ES
FR