Problem
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
There is too much condensed
water on the rear wall of the re-
frigerator.
Water flows inside the refriger-
ator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
14
Possible cause
The door is not closed correct-
ly.
The gasket is deformed or
dirty.
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
Appliance is fully loaded and is
set to the lowest temperature.
Temperature set in the appli-
ance is too low and the ambi-
ent temperature is too high.
During the automatic defrost-
ing process, frost melts on the
rear plate.
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Stored food was not wrapped.
Food products prevent the wa-
ter from flowing into the water
collector.
The water outlet is clogged.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The "FastCool function" is
switched on.
The temperature is not set cor-
rectly.
The door is not closed correct-
ly.
Solution
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products better.
Refer to "Control Panel" chap-
ter.
Set a higher temperature. Re-
fer to "Control Panel" chapter.
Set a higher temperature. Re-
fer to "Control Panel" chapter.
This is correct.
Open the door only when nec-
essary.
Make sure the door is closed
completely.
Wrap food in suitable packag-
ing before storing it in the ap-
pliance.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet
to the evaporative tray.
Switch off "FastCool function"
manually, or wait until the func-
tion deactivates automatically
to set the temperature. Refer
to "FastCool function" section.
Set a higher/lower tempera-
ture.
Refer to "Closing the door"
section.