Before Calling For Service; Error Code Table - Sharp XE-A201 Manual De Instrucciones

A201_5 OPERATOR MAINTENANCE
10

Before Calling for Service

The malfunctions shown in the left-hand column below, labelled "Fault," do not necessarily indicate functional
faults of the machine. It is therefore advisable to refer to "Checking" shown in the right-hand column before
calling for service.
(1) The display shows symbols that do not make sense.
(2) The display won't illuminate even when the mode switch
is turned to any other position than "
(3) The display is illuminated, but the whole machine
refuses registrations.
(4) No receipt is issued.
(5) No journal paper is taken up.
(6) Printing is unusual.

Error code table

When the following error codes are displayed, press the
below.
Error
code
E01
E02
E03
E07
E11
E12
E32
E34
E35
E36
E37
E67
Downloaded from: http://www.usersmanualguide.com/
01.11.11 10:24 AM
Fault
Error status
Registration error
Misoperation error
Undefined code is entered.
a
Memory is full (in the key programming).
s
Compulsory depression of the
direct finalization
Compulsory tendering
No entry of a clerk code
Overflow limitation error
The open price entry is inhibited.
The preset price entry is inhibited.
The direct finalization is inhibited.
Subtotal void is not allowed.
Page 67
• Has the machine been initialized properly as shown in
"GETTING STARTED"?
(Note that initialization clears all the data and programmed
settings stored in memory.)
• Is power supplied to the electrical outlet?
". • Is the power cord plug out or loosely connected to the
AC outlet?
• Is a clerk code assigned to the register?
• Is the mode switch set properly at the "REG" position?
• Is the paper roll properly installed?
• Is there a paper jam?
• Is the receipt function in the "OFF" status?
• Is the print head release lever at the printing position?
• Is the take-up spool installed on the bearing properly?
• Is there a paper jam?
• Is the journal printing selected in the printing style
programming? (If the receipt printing is selected, the paper
is not wound around the take-up spool.)
• Is the print head release lever at the printing position?
• Is the paper roll properly installed?
l
key and take a proper action according to the table
Make a correct key entry.
Make a correct key entry.
Enter a correct code
Program the
s
key for Press the
Make a tendering operation.
Make a clerk code entry.
Make a registration within a limit of entry.
Make a preset price entry.
Make an open price entry.
Make a tendering operation.
Finalize the transaction, and correct the wrong entries in the
mode.
Checking
Action
a
key within 25 steps.
key and continue the operation.
67