General Power Tool Safety Warnings - Makita DFT043F Manual De Instrucciones

ENGLISH (Original instructions)
1. Red part
2. Button
3. Battery cartridge
4. Indicator lamps
5. Check button
6. Switch trigger
7. Reversing switch lever
8. Front lamp
SPECIFICATIONS
Fastening torque
No load speed (min
Dimensions (L x W x H)
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest
combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
• Only use the battery cartridges and chargers listed above. Use of any other battery cartridges and chargers may
cause injury and/or fire.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
4
Explanation of general view
9. LED indicator
10. Adjust grip
11. Ring
12. Adjust ring
13. Scale
14. Hole for adjust grip
15. Yellow line
16. Compression spring
Model
Hard joint
Soft joint
-1
)
Net weight
BL1415N/BL1415NA/BL1430/BL1430B/BL1440/BL1450/BL1460A/BL1460B
DFT043F
1 - 4 N•m
1 - 4 N•m
80
DC18RC/DC18RD/DC18RE/DC18SD/DC18SE/DC18SF
CORDLESS SCREWDRIVER
ENE033-1
SAFETY WARNINGS
1. Hold the power tool by insulated gripping
surfaces, when performing an operation where the
fastener may contact hidden wiring. Fasteners
GEA010-2
contacting a "live" wire may make exposed metal parts
of the power tool "live" and could give the operator an
electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch the bit or the workpiece immediately
after operation; they may be extremely hot and
could burn your skin.
6. Always secure workpiece in a vise or similar hold-
down device.
17. Bit
18. Sleeve
19. Bit-piece
20. Limit mark
21. Brush holder cap
22. Screwdriver
DFT083F
3 - 8 N•m
3 - 8 N•m
80
200 mm x 72 mm x 255 mm
1.3 - 1.7 kg
D.C. 14.4 V
DFT125F
5 - 12 N•m
5 - 12 N•m
150
GEB139-1